TA3 SH3 SC3 Owner’s Manual
56
Formatting a USB flash drive
When a “UnF” message appears on the display indicating that the USB flash drive has not been formatted, format the
drive by the operation below.
NOTICE
Executing the Format operation will delete all data saved in the USB flash drive. Save important data to a computer or another
storage device.
NOTICE
While dashes appear in succession on the display, never turn off the power or disconnect the USB flash drive. Doing so may
corrupt the data on the USB flash drive, and the Format operation will not be executed properly.
1
Connect a USB flash drive to the [USB TO DEVICE] terminal.
2
Press the Menu button several times until the
[UTILITY] lamp lights up in orange.
3
Press Button 3 [Func.] to call up the Function
number in the display.
4
Rotate the [VALUE] control to select “F5.6”
(Formatting a USB flash drive).
5
Press Button 3 [Func.] to call up “For”
(Format) in the display.
An “n y” message appears.
NOTE
While “n y” is shown in the display, you can cancel the Format
operation by pressing a button other than Button 3 [Func.].
6
When “n y” appears, press Button 3 [Func.]
to execute the Format operation.
Dashes appear in succession on the display, indicating
that Formatting is in progress. When the operation is
completed, “End” appears on the display.
TA3
SH3
SC3
Lights up in orange
Function
number
Summary of Contents for TransAcoustic TA3
Page 4: ...TA3 SH3 SC3 Owner s Manual 4...
Page 85: ......