NAMES OF PARTS AND THEIR FUNCTIONS
4
En
X
Rear panel (Connecting antenna)
1
FM antenna terminal
: Connect the supplied indoor
FM antenna.
2
GND
:
Connect the cable core of the Indoor FM
antenna (see below).
3
AUX
: Connect an external device. (
4
USB FOR SYNC.
: Connect to PC. (
5
15V
: Connect supplied AC adaptor and power
cable.
6
CLOCK
: Adjust the clock. (
7
ALARM TYPE
: Set alarm type of IntelliAlarm
function. (
8
Indoor FM antenna
(supplied)
• The antenna should be stretched out.
• If you use an outdoor antenna instead of the supplied FM
antenna, reception will be better.
• If radio reception is poor, change the height, direction, or
placement of the antenna.
Connecting antenna to the GND terminal
It is recommended to connect the antenna to the GND terminal before connecting to the FM antenna terminal.
Notes
1
2
3
4
1
Remove insulation and
twist the edge of the
cord.
2
Fully screw down the GND terminal.
3
Wind the cord around the GND terminal. Make sure
the cord is wound inside of the ring part.
4
Tighten the GND terminal
taking care not to slip the cord
off from the terminal.
Ring