22
USING THE BUILT-IN TIMER
TONE
PROG
TOTAL
REP
RDS
AUTO
STEREO
PRESET
PSPTYRTCT
B. BOOST
RANDOM
S F
PTY HOLD
TUNED
MEMORY
SLEEP
TIMER
NATURAL SOUND CD RECEIVER
STANDBY/ON
OPEN/CLOSE
MEMORY
AUTO/MAN´L
TIMER
SLEEP
PRESET/TUNING
A/B/C/D/E
HOUR
MIN
MIN
HOUR
PHONES
DISPLAY
TIME ADJ
PRESET/BAMD
INPUT
SNOOZE
Timer play
By using the built-in timer, you can have the unit turn on
at a specified time and begin playing automatically. You
can also specify the turn off time.
3. ON Time
“ON Time” appears on the display for a second,
and then changes to the time setting mode.
佥
Press
HOUR –/+
to set the hour.
佥
Press
MIN –/+
to set the minute.
4. OFF Time
Set the time the same way as above.
If you set the ON time but not any OFF time,
timer play will finish automatically after an hour.
5. Timer Volume
You can specify the desired volume level for the
timer play by turning
VOLUME
or pressing
/–
on the remote control.
•
If you adjust this setting during play, the
volume of the currently playing material
changes so that you can confirm the volume
level for the timer play. When the display mode
changes, the volume reverts to the original level.
Note
• The display mode will change in about 8 seconds. If the
mode is changed before the setting is completed, call up
the mode again by pressing
DISPLAY
once or more.
2
Press
TIMER
to complete the timer setting.
• If you press
TIMER
during the “ON Time” or
“OFF Time” mode, the system is put in the
standby mode and “TIMER” lights up on the
display. To continue using the system, press
STANDBY/ON
to turn on this unit.
When timer play starts, the backlight of the volume
control starts flashing slowly.
•
If TUNER is selected as the timer source, the current
time and the frequency of the current station appears on
the display.
•
If CD has been selected as the timer source, the current
time and the current track number appears on the
display.
1
Press
DISPLAY
.
Whenever
DISPLAY
is pressed, the display mode
changes as follows:
1. Clock Time (TIMER on/off mode)
If you have not set the clock yet, “Set Clock”
appears. You need to set the current time as
described on page 12.
2. Timer Input
Select the source to be played by pressing
INPUT
.
• When you select TUNER, you can select the
desired preset station.
佥
Use
PRESET/BAND, A/B/C/D/E
and
PRESET/TUNING
/
on the main unit
or
PRESET
/
and
ABCDE
on the
remote control to select the station.
• When you select CD, the following display
appears. You can specify the desired track you
want to start playing and set the repeat and/or
random-sequence mode.
佥
Use
$
!
,
⁄
›
to specify the track.
佥
Press
REPEAT
on the remote control to set
the repeat mode.
佥
Press
RANDOM
on the remote control to set
the random-sequence mode.
MIN –
INPUT
SNOOZE
DISPLAY
HOUR –
TIMER
HOUR +
MIN +
STANDBY/ON
VOLUME
Current time
Frequency
Current time
Current track
09/TSX-10E(6.12)a
01.6.12, 4:18 PM
22
