3 - 19
INSP
ADJ
4. Inspect:
●
Brake fluid level
Refer to “BRAKE FLUID LEVEL
INSPECTION” section in the CHAP-
TER 3.
5. Check:
●
Brake lever operation
A softy or spongy feeling
→
Bleed
brake system.
Refer to “BRAKE SYSTEM AIR
BLEEDING” section.
FRONT BRAKE SHOE INSPECTION (TT-R125)
1. Inspect:
●
Brake shoe lining wear limit
●
Connect the transparent hose
4
to the
bleed screw
5
and place the suitable con-
tainer under its end.
●
Loosen the bleed screw and push the
brake caliper piston in.
CAUTION:
Do not reuse the drained brake fluid.
●
Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
●
Install the brake caliper
6
and brake cali-
per support bolt
7
.
NOTE:
Apply the lithium soap base grease on the
caliper support bolt.
T
R
.
.
Brake caliper support bolt:
22 Nm (2.2 m • kg, 16 ft • lb)
Brake shoe lining wear limit checking
steps:
●
Fully pull in the brake lever and hold it in
position.
●
Then check the brake shoe wear indicator
1
is within the wear limit
a
.
Outside the limit
→
Replace the brake
shoe.
Refer to “FRONT WHEEL AND FRONT
BRAKE” section in the CHAPTER 5.
FRONT BRAKE SHOE INSPECTION (TT-R125)
