3 - 20
INSP
ADJ
REAR BRAKE SHOE INSPECTION
1. Inspect:
●
Brake shoe lining wear limit
BRAKE FLUID LEVEL INSPECTION
(TT-R125LW)
1. Place the brake master cylinder so that
its top is in a horizontal position.
2. Inspect:
●
Brake fluid level
Fluid at lower level
→
Fill up.
a
Lower level
WARNING
●
Use only designated quality brake fluid to
avoid poor brake performance.
●
Refill with same type and brand of brake
fluid; mixing fluids could result in poor
brake performance.
●
Be sure that water or other contaminants
do not enter brake master cylinder when
refilling.
●
Clean up spilled fluid immediately to
avoid erosion of painted surfaces or plas-
tic parts.
Brake shoe lining wear limit checking
steps:
●
Fully push down the brake pedal and hold
it in position.
●
Then check the brake shoe wear indicator
1
is within the wear limit
a
.
Outside the limit
→
Replace the brake
shoe.
Refer to “REAR WHEEL AND REAR BRAKE”
section in the CHAPTER 5.
Recommended brake fluid:
DOT #4
SPROCKETS INSPECTION
1. Inspect:
●
Sprocket teeth
a
Excessive wear
→
Replace.
NOTE:
Replace the drive, driven sprockets and drive
chain as a set.
REAR BRAKE SHOE INSPECTION/BRAKE FLUID LEVEL
INSPECTION (TT-R125LW)/SPROCKETS INSPECTION
