3 - 31
INSP
ADJ
STEERING HEAD INSPECTION AND ADJUSTMENT
●
Tighten the lower ring nut
6
using steer-
ing nut wrench
7
and turn the steering
right and left a few times.
NOTE:
Set the torque wrench to the steering nut
wrench so that they form a right angle.
Steering nut wrench:
YU-33975/90890-01403
T
R
.
.
Lower ring nut (initial tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
●
Loosen the lower ring nut one turn.
●
Retighten the lower ring nut using the
steering nut wrench.
WARNING
Avoid over-tightening.
T
R
.
.
Ring nut (final tightening):
20 Nm (2.0 m • kg, 14 ft • lb)
●
Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
●
Install the rubber washer
8
, upper ring
nut
9
and special washer
0
.
NOTE:
●
Tighten the upper ring nut until it contacts
the rubber washer.
●
Insert the special washer pawls into the
slots. If the slots are not aligned, tighten
the upper ring nut for alignment.
●
Install the upper bracket
A
, steering stem
nut
B
, cap
C
, handlebar
D
, upper han-
dlebar holder
E
, main switch
F
, starter
knob nut
G
and number plate
H
.
NOTE:
●
The upper handlebar holder should be
installed with the punched mark
a
for-
ward.
●
Insert the end of fuel breather hose
I
into
the hose clamp.
H
D
F
B
C
I
A
Summary of Contents for TT-R125(W) 2006
