4 - 18
ENG
VALVES AND VALVE SPRINGS
Valve spring
1. Measure:
●
Valve spring free length
a
Out of specification
→
Replace.
2. Measure:
●
Spring tilt
a
Out of specification
→
Replace.
Free length (valve spring):
Intake:
32.45 mm (1.28 in)
<Limit>: 26.9 mm (1.06 in)
Exhaust:
32.45 mm (1.28 in)
<Limit>: 26.9 mm (1.06 in)
Spring tilt limit:
Intake:
2.5˚/1.4 mm (0.06 in)
Exhaust:
2.5˚/1.4 mm (0.06 in)
Valve seat
1. Measure:
●
Valve seat width
a
Out of specification
→
Reface the valve
seat.
Valve seat width:
Intake:
0.9 ~ 1.1 mm (0.0354 ~ 0.0433 in)
<Limit>: 1.6 mm (0.0630 in)
Exhaust:
0.9 ~ 1.1 mm (0.0354 ~ 0.0433 in)
<Limit>: 1.6 mm (0.0630 in)
Measurement steps:
●
Apply Mechanic’s blueing dye (Dykem)
b
to the valve face.
●
Install the valve into the cylinder head.
●
Press the valve through the valve guide
and onto the valve seat to make a clear
pattern.
●
Measure the valve seat width. Where the
valve seat and valve face made contact,
blueing will have been removed.
●
If the valve seat is too wide, too narrow, or
the seat is not centered, the valve seat
must be refaced.
Summary of Contents for TT-R90(T)
