10
10
C
onnections – U
sing
T
yr
os3 with O
ther D
evices –
114
• Tyros3 Reference Manual
MIDI SYSTEM Settings
The explanations here apply to the SYSTEM Page in step 4 on
Use the [A]/[B] buttons to select the parameters (below), then set the ON/OFF status by using the [1
▲▼
]–[8
▲▼
]
buttons.
■
1 Local Control
Turns the Local Control for each part on or off. When Local Control is set to
“ON,” the keyboard of the Tyros3 controls its own (local) internal tone gener-
ator, allowing the internal Voices to be played directly from the keyboard. If
you set Local to “OFF,” the keyboard and controllers are internally discon-
nected from the Tyros3’s tone generator section so that no sound is output
when you play the keyboard or use the controllers. For example, this allows
you to use an external MIDI sequencer to play the Tyros3’s internal Voices, and
use the Tyros3 keyboard to record notes to the external sequencer and/or play
an external tone generator.
■
2 Clock setting, etc.
●
CLOCK
Determines whether the Tyros3 is controlled by its own internal clock or a
MIDI clock signal received from an external device. INTERNAL is the normal
Clock setting when the Tyros3 is being used alone or as a master keyboard to
control external devices. If you are using the Tyros3 with an external
sequencer, MIDI computer, or other MIDI device, and you want to synchronize
it to that device, set this parameter to the appropriate setting: MIDI A, MIDI B,
USB 1, or USB 2. In this case, make sure that the external device is connected
properly (e.g., to the Tyros3’s MIDI IN terminal), and that it is properly trans-
mitting a MIDI clock signal.
●
TRANSMIT CLOCK
Turns MIDI clock (F8) transmission on or off. When set to OFF, no MIDI clock
or Start/Stop data is transmitted even if a Song or Style is played back.
●
RECEIVE TRANSPOSE
Determines whether or not the Tyros3’s transpose setting is applied to the
note events received by the Tyros3 via MIDI.
●
START/STOP
Determines whether incoming FA (start) and FC (stop) messages affect Song
or Style playback.
■
3 MESSAGE SW (Message Switch)
●
SYS/EX.
The “Tx” setting turns MIDI transmission of MIDI System Exclusive messages
on or off. The “Rx” setting turns MIDI reception and recognition of MIDI Sys-
tem Exclusive messages generated by external equipment on or off.
●
CHORD SYS/EX.
The “Tx” setting turns MIDI transmission of MIDI chord exclusive data (chord
detect. root and type) on or off. The “Rx” setting turns MIDI reception and
recognition of MIDI chord exclusive data generated by external equipment on
or off.
If the Clock is set other than INTERNAL,
the Style, Song or Multi Pad cannot be
played from the panel buttons.
NOTE
Summary of Contents for Tyros3
Page 1: ...EN Reference Manual ...
