8-41
8
EBU33030
Wheel installation
1. Install the wheel and the nuts.
TIP
For YXM70VDXG / YXM70VDHG /
YXM70VPXG / YXM70VPHG: tapered nuts
are used for both the front and rear wheels.
Install the nuts with their tapered side towards
the wheel.
YXM70VDXG / YXM70VDHG /
YXM70VPXG / YXM70VPHG
2. Lower the vehicle so that the wheel is on
the ground.
3. Tighten the wheel nuts in a crisscross
pattern to the specified torque.
WARNING
EWB03400
Do not reverse the rims on your Yamaha
Viking to widen the track width. Installing
wheels improperly increases the risk of
wheel failure and accidents.
EBU32640
Battery
The battery is located under the hood. (See
page 8-10 for hood removal and installation
procedures.)
1. Tapered nut
1
Tightening torques:
Front wheel nut:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Rear wheel nut:
75 Nm (7.5 m·kgf, 54 ft·lbf)
UB4210E0.book Page 41 Tuesday, April 28, 2015 1:25 PM