30
MIDI DATA FORMAT
[VL-XG Format]
F0H, 43H, 0nH, 4CH, bmH, blH, ahH, amH, alH, ddH, ~, ddH,
ccH, F7H
0n : n=Device Number
bm : Byte Count MSB
bl : Byte Count LSB
ah : Address High
am : Address Mid
al : Address Low
dd : Data
cc : Check Sum
1)
System Parameter
See <Table 3>.
2)
System Information
Send Only.
See <Table 4>.
3)
Current Voice / Common Part Parameter
See <Table 7>.
When sent, the established Part Number is used.
When this message is received in the Voice Mode, the
Part Number is fixed to 1.
In the VL-XG Mode, this message will be received, if
the Part Numbers are in agreement.
4)
Current Voice / Common Effect Parameter See <Table 8>.
<BULK DUMP REQUEST>
F0H, 43H, 2nH, 57H or 4CH, ahH, amH, alH, F7H
2n : n=Device Number
ah : Address High
am : Address Mid
al : Address Low
Receive Only
The corresponding Bulk Dump will be sent.
In the Voice Mode, Model ID = 57H is transmitted, in the VL-
XG Model ID = Channel 4 is transmitted.
For the Address and Byte Count, refer to the supplementary
tables.
Here, the Byte Count is indicated by the “TOTAL SIZE” in
the table.
The block’s leading byte is the Bulk Dump and Dump Request’s
Address.
A “Block” is the lumped together unit which is indicated by
the “Total Size”.
The Check Sum is the value that results in a value of 0 for the
lower 7 bits when the Start Address, Byte Count, Data, plus
the Check Sum itself are added.
8. REALTIME MESSAGES
<Active Sensing>
Status
:FEH
Not Transmitted.
Once Active Sensing is received, if no MIDI data is received
for longer than an interval of 300msec, the instrument will
perform the same function as when ALL SOUND OFF and
ALL NOTE OFF, RESET ALL CONTROLLER messages are
received, and will return to a status in which Active Sensing is
not monitored.
