4 - 83
ENG
CONNECTING RODS AND PISTONS
2. Position:
• top ring
• 2nd ring
• oil ring
Offset the piston ring end gaps as shown.
a
Top ring end
b
Lower oil ring end
c
Upper oil ring end
d
2nd ring end
3. Install:
• piston
1
• piston pin
2
• piston pin clip
3
NOTE:
@
• Apply engine oil onto the piston pin.
• Be sure that the piston is positioned cor-
rectly, as shown in the illustration.
@
4
“Y” mark
5
“EX” exhaust side
6
“IN” exhaust side
7
Projection
New
4. Install:
• big end bearings
1
NOTE:
• Align the projections
a
on the big end bear-
ings with the notches
b
in the connecting
rods and connecting rod caps.
• Be sure to reinstall each big end bearing in
its original place.
5. Lubricate:
• piston
• piston rings
• cylinder
(with the recommended lubricant)
Recommended lubricant
Engine oil
Summary of Contents for VMX12 2001
