3 - 24
CHK
ADJ
BLEEDING THE HYDRAULIC CLUTCH SYSTEM
EAS00085
BLEEDING THE HYDRAULIC CLUTCH
SYSTEM
WARNING
@
Bleed the hydraulic clutch system when-
ever:
• the system was disassembled,
• a clutch hose was loosened or removed,
• the clutch fluid level is very low,
• clutch operation is faulty.
@
NOTE:
@
• Be careful not to spill any clutch fluid or allow
the clutch fluid reservoir to overflow.
• When bleeding the hydraulic clutch system,
make sure there is always enough clutch
fluid before applying the clutch lever. Ignor-
ing this precaution could allow air to enter the
hydraulic clutch system, considerably length-
ening the bleeding procedure.
• If bleeding is difficult, it may be necessary to
let the clutch fluid settle for a few hours.
Repeat the bleeding procedure when the tiny
bubbles in the hose have disappeared.
@
1. Bleed:
• hydraulic clutch system
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Add the recommended clutch fluid to the
proper level.
b. Install the clutch fluid reservoir diaphragm.
c. Connect a clear plastic hose
1
tightly to the
bleed screw
2
.
d. Place the other end of the hose into a con-
tainer.
e. Slowly squeeze the clutch lever several
times.
f. Fully squeeze the clutch lever without
releasing it.
g. Loosen the bleed screw. This will release
the tension and cause the clutch lever to
contact the handlebar grip.
h. Tighten the bleed screw and then release
the clutch lever.
Summary of Contents for VMX12 2001
