6-21
E
JET
PUMP
BEARING HOUSING
2. Install:
●
Intermediate drive shaft
NOTE:
Support the intermediate housing with
steel blocks
1
and press the driven cou-
pling shaft.
3. Install:
●
Oil seal
1
[8 mm (0.31 in)]
●
Oil seal
2
[10 mm (0.39 in)]
Distance
a
:
9.5 ~ 10.5 mm (0.37 ~ 0.41 in)
Distance
a
:
10.3 ~ 10.7 mm (0.41 ~ 0.42 in)
Distance
b
:
1.6 ~ 2.0 mm (0.06 ~ 0.08 in)
Intermediate housing installation
1. Install:
●
Intermediate housing
●
Shim
NOTE:
Install the shim(s) to the original position if
the intermediate housing is not replaced.
Installation steps:
●
Install the intermediate housing.
●
Measure the clearance
a
at each bolt
hole.
●
Install the suitable shim from the table
below.
Clearance
a
Shim
thickness
0 ~ 0.2 mm
(0 ~ 0.008 in)
No need
0.3 ~ 0.7 mm
(0.012 ~ 0.028 in)
0.5 mm
0.8 ~ 1.2 mm
(0.031 ~ 0.047 in)
1.0 mm
1.3 ~ 2.0 mm
(0.051 ~ 0.079 in)
1.5 mm
