3-4
E
INSP
ADJ
CONTROL SYSTEM
QSTS cable inspection and adjustment
1. Measure:
• Jet thrust nozzle set lengths
a
and
b
Out of specification
→
Adjust.
Measurement steps:
• Set the control grip to the neutral posi-
tion.
• Set the jet thrust nozzle in the center
position.
• Measure jet thrust nozzle set lengths
a
and
b
.
• If lengths
a
and
b
are not even, adjust
the cable joint.
2. Adjust:
• QSTS cable
Adjustment steps:
• Set the control grip to the neutral posi-
tion.
• Loosen the locknut
1
.
• Remove the nut
2
and pivot pin
3
.
• Set the jet thrust nozzle in the center
position.
• Turn the cable joint
4
in or out to adjust
lengths
a
and
b
.
Turn in
Length
b
is increased.
Turn out
Length
a
is increased.
WARNING
The cable joint must be screwed in a
minimum of 8 mm (0.31 in).
• Connect the cable joint
4
and pivot pin
3
, and then tighten the nut
2
.
T
R
.
.
Nut:
3.8 N • m (0.38 kgf • m, 2.7 ft • lb)
• Tighten the locknut
1
.
T
R
.
.
Locknut:
4 N • m (0.4 kgf • m, 2.9 ft • lb)
Summary of Contents for WaveRunner GP1300R
