6-13
E
JET
PUMP
IMPELLER DUCT AND DRIVE SHAFT
5. Install:
• Rear bearing
NOTE:
• Press the bearing inner/outer race at the
same time holding the drive shaft and impel-
ler duct.
• If a bearing inner/outer race attachment is
not available, use a washer or pipe with an
outer diameter of 47–50 mm (1.85–1.97 in)
and an inner diameter of 21–25 mm (0.83–
0.98 in).
Drive shaft needle bearing depth
stop:
YB-34474
6. Add:
• EPNOC grease AP #0 (into the cap)
Quantity:
Approximately 1/3 of capacity
7. Install:
• Nut
• Impeller
T
R
.
.
Drive shaft nut:
74 N • m (7.4 kgf • m, 53 ft • lb)
Impeller:
75 N • m (7.5 kgf • m, 54 ft • lb)
LOCTITE 572
Drive shaft holder:
YB-06151
Drive shaft holder 5:
90890-06519
Summary of Contents for WaveRunner GP1300R
