6-23
E
JET
PUMP
BEARING HOUSING
3. Install:
• Oil seal
1
[8 mm (0.31 in)]
• Oil seal
2
[10 mm (0.39 in)]
Distance
a
:
10.3–10.7 mm (0.41–0.42 in)
Distance
b
:
1.6–2.0 mm (0.06–0.08 in)
b
a
2
1
Intermediate housing installation
1. Install:
• Intermediate housing
• Shim(s)
• Bolts
NOTE:
Install shims in their original positions if the
intermediate housing is not replaced.
Installation steps:
• Install the intermediate housing.
• Measure the clearance
a
at each bolt
hole.
• Install the suitable shim from the table
below.
Clearance
a
Shim
thickness
0–0.2 mm
(0–0.008 in)
Not needed
0.3–0.7 mm
(0.012–0.028 in)
0.5 mm
0.8–1.2 mm
(0.031–0.047 in)
1.0 mm
1.3–2.0 mm
(0.051–0.079 in)
1.5 mm
T
R
.
.
Intermediate housing bolt:
17 N • m (1.7 kgf • m, 12 ft • lb)
LOCTITE 572
Summary of Contents for WaveRunner GP1300R
