Excluding Certain Channels from Aux Sends (Mix Minus)
117
DM2000 Version 2—Owner’s Manual
Excluding Certain Channels from Aux Sends (Mix Minus)
You can quickly exclude certain channel signals from Aux Sends by using the controls on
the top panel. This operation is called “Mix Minus.”
For example, when Aux Sends are being used as monitors for the musicians or a narrator,
you can turn off the audio signals of the musicians or narrator, excluding them from the
monitor sound.
1
Press and hold down the AUX SELECT [AUX 1]–[AUX 12] buttons of the
desired Aux Sends.
The [ON] button indicators in the channel strip remain lit while you hold down the button.
This means that signals routed from channels with a lit [ON] button indicator to the Aux
Send are turned on.
2
Press the [ON] buttons of the Input Channels you wish to exclude from the
Aux Send. You can select multiple channels.
The selected channels’ [ON] button indicators turn off, and signals routed from those
channels to the corresponding Aux Send are turned off. “MIX MINUS FOR AUX * ”
appears at the bottom of the screen. (The asterisk represents an Aux number.)
3
To reset the setting, while pressing and holding down the AUX SELECT
[AUX 1]–[AUX 12] buttons you pressed in Step 1, press the [ON] buttons you
pressed in Step 2.
The corresponding [ON] button indicators light up.
Note: If you release the AUX SELECT button before you proceed to Step 2, you will be unable
to complete the Mix Minus operation.
Tip: At this time, the Send Level controls on the Aux Send page are grayed out.
