Stereo Out
65
DM2000 Version 2—Owner’s Manual
PEAK & SIGNAL Indicators
These indicators are used in conjunction with the GAIN controls and PAD
switches to optimize signal levels. The SIGNAL indicator lights up when the
input signal level is 20 dB below the rated level. The PEAK indicator lights up
when the input signal level is 3 dB below clipping.
AD Inserts
AD Inputs feature switchable analog inserts with individual balanced 1/4-inch
TRS phone jacks for the send and return signals. They are wired:
sleeve–ground, ring–cold, tip–hot. The rated level for both connectors is +4 dB.
AD Input inserts can be turned on and off individually by using the INSERT
ON/OFF switches, so you don’t have to disconnect your external equipment in
order to remove an insert.
Stereo Out
See page 104 for information on the Stereo Out outputs.
Control Room Monitor Outs
See page 158 for information on the Control Room Monitor outputs.
Studio Monitor Outs
See page 159 for information on the Studio Monitor outputs.
Omni Outs
The DM2000 features assignable Omni Outs on balanced 1/4-inch TRS phone jacks. Omni
Outs can be patched to Bus Outs, Aux Sends, Matrix Sends, the Stereo Out, Input or Output
Channel Insert Outs, or Surround Monitor Channels (see page 80). In addition, Input
Channel Direct Outs can be patched to the Omni Outs (see page 81).
The maximum output level of each OMNI OUT can be set internally to 4 dB
(–10 dB operating level) or +18 dB (+4 dB operating level). Contact your dealer for further
details.
2TR Analog INs
The DM2000 features two sets of 2-track analog inputs: 2TR IN ANALOG 1
+4 dB (BAL) uses balanced 1/4-inch TRS phone jacks. 2TR IN ANALOG 2
–10 dBV (UNBAL) uses unbalanced phono jacks. These inputs can be moni-
tored via the Control Room monitors by pressing the CONTROL ROOM
[2TR A1] and [2TR A2] buttons. They can be patched to Input Channels (see
page 77), Input Channel Insert Ins (see page 78), or Output Channel Insert Ins
(see page 80).
PEAK
SIGNAL
OFF
ON
INSERT
