Operation an
d
important ri
d
in
g
points
6-2
6
EAU78231
Startin
g
the en
g
ine
NOTICE
ECA10251
See pa
g
e 6-5 for en
g
ine
b
reak-in in-
structions prior to operatin
g
the ve-
hicle for the first time.
In order for the ignition circuit cut-off
system to enable starting, the side-
stand must be up. (See page 4-27.)
1. Turn the main switch on and make
sure that the stop/run/start switch
is set to “
”.
The following warning lights and
indicator lights should come on for
a few seconds, then go off.
Engine trouble warning light
Traction control system indi-
cator light
Smart key system indicator
light
TIP
The ABS warning light should come on
and stay on until the vehicle reaches a
traveling speed of 10 km/h (6 mi/h) or
higher.
NOTICE
ECA22510
If a warnin
g
or in
d
icator li
g
ht
d
oes
not work as
d
escri
b
e
d
a
b
ove, see
pa
g
e 4-1 for the correspon
d
in
g
warnin
g
an
d
in
d
icator li
g
ht circuit
check.
2. Close the throttle.
3. While applying the front or rear
brake, push the “
” side of the
stop/run/start switch. Release it
when the engine starts.
TIP
If the engine does not start, release the
start switch after 5 seconds. Before
pressing the start switch again, wait 10
seconds to allow battery voltage to re-
store.
NOTICE
ECA11043
For maximum en
g
ine life, never ac-
celerate har
d
when the en
g
ine is
col
d
!
UBL2E0E0.book Page 2 Friday, June 23, 2017 9:30 AM