4-2
3)
Connect both the garden hose
adapter and a water tap using a hose.
4)
Start the engine. Then, immediately
turn on water supply until the water
flows out continually from the cooling
water pilot outlet.
5)
Run the engine at an idle speed for 10
to 15 minutes watching engine condi-
tion.
If the engine stopped while flushing,
turn off water supply immediately.
Repeat above steps.
6)
Turn off the water supply. Then, force
the remaining water out from the
cooling passages by quickly opening
and closing the throttle several times
within 10 to 15 seconds.
7)
Stop the engine.
8)
Remove the garden hose adapter and
secure the cap.
E
