0QFSBUJPOBOEJNQPSUBOUSJEJOHQPJOUT
7-2
EAU78231
4UBSUJOHUIFFOHJOF
NOTICE
ECA10251
4FFQBHFGPSFOHJOFCSFBLJOJO
TUSVDUJPOTQSJPSUPPQFSBUJOHUIFWF
IJDMFGPSUIFãSTUUJNF
In order for the ignition circuit cut-off
system to enable starting, the side-
stand must be up. (See page 5-24.)
1. Turn the main switch on and make
sure that the stop/run/start switch
is set to “
”.
The following warning lights and
indicator lights should come on for
a few seconds, then go off.
Engine trouble warning light
Traction control system indi-
cator light
Smart key system indicator
light
5*1
The ABS warning light should come on
and stay on until the vehicle reaches a
traveling speed of 10 km/h (6 mi/h) or
higher.
NOTICE
ECA22510
*G B XBSOJOH PS JOEJDBUPS MJHIU EPFT
OPU XPSL BT EFTDSJCFE BCPWF TFF
QBHF GPS UIF DPSSFTQPOEJOH
XBSOJOH BOE JOEJDBUPS MJHIU DJSDVJU
DIFDL
2. Close the throttle.
3. While applying the front or rear
brake, push the “
” side of the
stop/run/start switch. Release it
when the engine starts.
5*1
If the engine does not start, release the
start switch after 5 seconds. Before
pressing the start switch again, wait 10
seconds to allow battery voltage to re-
store.
NOTICE
ECA11043
'PSNBYJNVNFOHJOFMJGFOFWFSBD
DFMFSBUF IBSE XIFO UIF FOHJOF JT
DPME
EAU45093
4UBSUJOHPGG
1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signals on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signals off.
1. Grab bar
1