SIGNALING SYSTEM
– 51 –
EAS30501
TROUBLESHOOTING
• Any of the following fail to light: turn signal light, brake light or an indicator light.
• The horn fails to sound.
• The fuel meter fails to come on.
• The speedometer fails to operate.
TIP
• Before troubleshooting, remove the following part(s):
1. Battery cover
2. Fuel tank center cover/Air scoops
3. Fuel tank
4. Drive sprocket cover
5. Headlight assembly
NG
→
OK
↓
NG
→
OK
↓
NG
→
OK
↓
NG
→
OK
↓
1. Check the fuses.
(Parking lighting, ABS control unit,
ignition, signaling system, backup
2, backup, and main)
Refer to “CHECKING THE FUS-
ES” on page 81.
Replace the fuse(s).
2. Check the battery.
Refer to “CHECKING AND
CHARGING THE BATTERY” in
chapter 8. (Manual No.: B34-
F8197-E2)
• Clean the battery terminals.
• Recharge or replace the battery.
3. Check the main switch.
Refer to “CHECKING THE
SWITCHES” in chapter 8. (Manual
No.: B34-F8197-E2)
Replace the main switch/immobilizer unit.
4. Check the entire signaling system
wiring.
Refer to “CIRCUIT DIAGRAM” on
page 49.
Properly connect or replace the wiring har-
ness.
Check the condition of each of the sig-
naling system circuits. Refer to
“Checking the signaling system” on
page 52.
Summary of Contents for XSR700 2018
