Periodic maintenance and adjustment
7-12
7
4. Clean the engine oil strainer with
solvent, and then check it for
damage and replace it if neces-
sary.
TIP
Skip steps 5–7 if the oil filter element is
not being replaced.
5. Remove the oil filter element cover
by removing the bolts.
6. Remove and replace the oil filter
element and O-ring.
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
TIP
Make sure that the O-ring is properly
seated.
8. Install the engine oil strainer, com-
pression spring, new O-ring and
engine oil drain bolt, and then
tighten the drain bolt to the speci-
fied torque.
NOTICE:
Before in-
stalling the engine oil drain bolt,
do not forget to install the O-
ring, compression spring, and
oil strainer in position.
[ECA10422]
1. Engine oil drain bolt
2. O-ring
3. Compression spring
4. Strainer
5. Oil pan
4
5
3
2
1
1. Bolt
2. Oil filter element cover
1. Oil filter element
2. O-ring
1
2
1
2
Tightening torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Tightening torque:
Engine oil drain bolt:
32 N·m (3.2 kgf·m, 24 lb·ft)
