8
En
Placing this system
■
Attaching the center system to a wall
You can attach the center system to a wall using commercially available screws (#8, Diameter: 7.5 mm or more
(9/32” or more)).
1
Attach the supplied mounting template on a
wall and then mark the holes of the mounting
template.
2
Remove the mounting template and then
install the commercially available screws at
the marks.
y
To install the cables above the center system, refer to the right
column.
3
Hang the center system on the screws using
the holes on the back of the center system.
• The center system weighs about 4.5 kg (9 lbs. 15 oz.). To attach the center system to a wall using screws, the wall must be firm. Do not
attach the center system to a wall that is made of weak materials such as plaster or veneered woods. Doing so may cause the center
system to fall.
• Use commercially available screws that can endure weight enough.
• Make sure you use specified screws to attach the center system to a wall. Using clamps other than specified screws, such as short
screws, nails, or two-sided tape, may cause the center system to fall.
• When connecting the center system, fix the speaker cables in place so that cables do not loosen. If your foot or hand accidentally gets
caught on a loose speaker cable, the center system may fall.
• After attaching the center system, check that the center system is fixed securely. Yamaha will bear no responsibility for any accidents
caused by improper installations.
When installing the center system on a wall, all installation work must be performed by a qualified contractor or
dealer personnel. The customer must never attempt to perform this installation work. Improper or inadequate
installation could cause the center system to fall, resulting in personal injury.
Tapes or thumbtacks
Mark
4 to 6 mm (3/16” to 1/4”)
Diameter:
7.5 mm or more
(#8, 9/32” or more)
Installing the cables above the center system
To pass the cables upward, you need to attach the
spacers to make room on the back of the center system.
In step 2 of the left column;
2-a
: Attach the supplied spacers to the rear panel of the
center system using the supplied double-sided
tapes. You can choose either the side A or the side
B.
2-b
: Remove the mounting template and then install
the commercially available screws at the marks.
For narrow space
For wide space
Large double-
sided tape
Small double-
sided tape
Attach
Attach
22 to 24 mm
(7/7” to 15/16”)
34 to 36 mm
(5/16” to 7/16”)
Notes
