Yamaha YAS-81, Owner'S Manual

USING OPTIONAL EQUIPMENT

30

 En

4

Press and hold 

BLUETOOTH ON

 for more than 3 seconds to start pairing.

“Searching...” appears when the pairing starts. While the Yamaha Bluetooth wireless audio receiver is in pairing 
mode, the DOCK indicator flashes in the front panel display.

y

To cancel the pairing, press 

BLUETOOTH OFF

.

5

Check that the Bluetooth component detects the Yamaha Bluetooth wireless audio receiver.

If the Bluetooth component detects the Yamaha Bluetooth wireless audio receiver, the audio receiver name (“YBA-
10 YAMAHA” for example) appears in the device list of the Bluetooth component.

6

Select the Yamaha Bluetooth wireless audio receiver in the device list of the Bluetooth 
component, and then enter the pass key “0000” on the Bluetooth component.

When the pairing procedure is successful, “Completed” appears in the front panel display.

y

• If the pairing is not completed within 8 minutes, “Not found” appears and the DOCK indicator is turned off in the front panel 

display.

• If the pairing is canceled during the pairing, “Canceled” appears in the front panel display.

The Yamaha Bluetooth wireless audio receiver can be paired with up to eight Bluetooth components. When pairing is conducted 
successfully with a ninth component and the pairing data is registered, the pairing data for the least recently used another component is 
deleted.

■

Establishing a connection

After the pairing is completed, perform the connecting operation on the system or on the Bluetooth component to enable 
communication between them. The connecting operation on the system is only available for the most recently connected 
Bluetooth component.

1

Press 

DOCK 

to set the input to DOCK.

2

Press 

BLUETOOTH ON

 to start a connection. “Searching...” appears in the front panel display.

When the system finds the last connected Bluetooth component, “BT connected” appears in the front panel display 
for 3 seconds.

y

• If the system cannot find the last connected Bluetooth component, “Not found” appears in the front panel display.
• If you want to establish a connection with a Bluetooth component other than the one most recently connected to, connect from 

that Bluetooth component. Refer to the instruction manual of your Bluetooth component for details.

■

Disconnecting

Press 

DOCK

, and then 

BLUETOOTH OFF

 to disconnect the system from the Bluetooth 

component. 

“Disconnected” appears in the front panel display.

■

Playing back the Bluetooth component

You can play back your Bluetooth component using the supplied remote control.
You can also play back your Bluetooth component by operating it directly.

y

Operation using the remote control is available only when the connection is established between the Bluetooth component you want to 
play back and the system.

Note