6
En
Connections
Power cable
To AC wall outlet
Sound bar (rear)
Optical cable
Optical cable
Playback device (such as a BD player)
Set top box
OPTICAL OUTPUT
OPTICAL OUTPUT
TV
HINT
In the following cases, connect the optical
output of the playback device to the BD/DVD
input of the sound bar with an optical cable
(commercially available), then select the BD/
DVD key on the remote control for the input
source.
− The TV does not have an optical output.
− The TV does not output audio (or outputs
low volume audio) from the connected
playback device.
− The audio from the playback device
connected to the TV cannot be heard as
surround sound.
Connect to a TV (or other peripheral device).
HINT
• If a setting to disable the speaker output is not available on your TV, you may disable it
by connecting headphones to the headphone jack on the TV. For details, refer to the
manuals of the TV.
• The TV, BD/DVD and COAXIAL input jacks support the following audio signals.
− PCM (2 channel)
− Dolby Digital (up to 5.1 channel)
− DTS Digital Surround (up to 5.1 channel)
CAUTIONS
• Do not connect the power cable of the sound bar to the AC wall outlet before making
connections.
• Do not use excessive force when inserting the cable plug. Doing so may damage the
cable plug or AC wall outlet.
1
Connect the TV and sound bar with the optical
cable (supplied).
Remove the cap of the optical cable and check the
direction of the plug.
2
Connect the power cable of the sound bar to an
AC wall outlet.
3
Set the TV as follows.
• Set the TV volume to minimum.
• Disable the TV built-in speaker output (if available).
HDMI cable (etc.)
