12
En
PREPARATION
➤
Installation
Installing the unit on a TV stand, etc.
Position the unit so that the keys are on the far side of the unit.
About the TV remote repeater
The unit receives signals from the TV’s remote control via the remote control sensor
located on the front panel. It then transmits these signals from the TV remote repeater
located on the rear panel. See page 10 in the Owner’s Manual for more information.
Mounting the unit on a wall
Mount the unit on the wall so that the keys face upwards. Follow the instructions
on page 11 in the Owner’s Manual when mounting the unit on a wall.
Remote control sensor (front panel)
Keys
TV remote repeater
TV’s remote control
More than 5 cm (2 in)
TV remote control sensor
Caution
• When mounting the unit on a wall, all installation work must be performed by a qualified contractor or
dealer. The customer must never attempt to perform this installation work. Improper or inadequate
installation could cause the unit to fall, resulting in personal injury.
Keys
Remote control sensor
(top panel)
