4-4
4
EBU18061
Handlebar switches
EBU18080
Engine stop switch “
/
”
Set this switch to “
” before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to “
”.
EBU18101
Start switch “
”
Push this switch to crank the engine with the start-
er. See the starting instructions on page 6-1 prior
to starting the engine.
EBU18154
Light switch “
/
/OFF”
Set this switch to “
” to turn on the low beams
and the taillight. Set the switch to “
” to turn on
the high beams and the taillight. Set the switch to
“OFF” to turn off all the lights.
NOTICE
ECB00043
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it. (See page 8-46.)
EBU18282
Throttle lever
Once the engine is running, pushing the throttle le-
ver will increase the engine speed.
1. Light switch “
/
/OFF”
2. Engine stop switch “
/
”
3. Start switch “
”
1
2
3
U1PE61E0.book Page 4 Thursday, April 4, 2013 6:18 PM
Summary of Contents for YFM700RE
Page 17: ...1 7 1 For Oceania 4 5 2 3 1 1 U1PE61E0 book Page 7 Thursday April 4 2013 6 18 PM ...
Page 70: ...7 1 7 EBU21141 RIDING YOUR ATV U1PE61E0 book Page 1 Thursday April 4 2013 6 18 PM ...
Page 158: ...11 2 11 1 Model label 1 U1PE61E0 book Page 2 Thursday April 4 2013 6 18 PM ...
Page 161: ...U1PE61E0 book Page 3 Thursday April 4 2013 6 18 PM ...