8 - 40
–
+
ELEC
YES
NO
5. The fuel level warning light fails to come on.
YES
NO
3. Voltage
• Connect the pocket tester (DC 20 V) to the
indicator light assembly coupler (wire har-
ness side) as shown.
Positive tester probe
→
brown
1
Negative tester probe
→
white/blue
2
• Set the main switch to “ON”.
• Measure the voltage (DC 12 V) of brown
1
and white/blue
2
at the indicator light
assembly coupler (wire harness side).
NOTE:
The voltage can only be measured during the
initial test of the indicator light assembly after
the main switch is set to “ON”.
• Is the voltage within specification?
This circuit is OK.
The
wiring
circuit
from the main switch
to the indicator light
assembly coupler is
faulty and must be
repaired.
W
/
L G
/
L Sb
Br O
/
B G
/
Y
Lg G
/
L W
/
L
G
/
Y O
/
B Br
1
2
1. Indicator light assembly
• Disconnect the indicator light assembly
coupler from the wire harness.
• Connect the battery (12V) to the indicator
light assembly coupler as shown.
• When the jumper leads are connected to
the terminals the fuel level warning light
should illuminate.
Positive battery terminal
→
brown
1
Negative battery terminal
→
orange/black
2
• Is the indicator light assembly OK?
Replace the indica-
tor light assembly.
W
/
L G
/
L Sb
Br O
/
B G
/
Y
1
2
Summary of Contents for YFM700RV 2009
