8-27
8
4. Install the gasket, tailpipe, and retainer and
align the bolt holes.
5. Install the bolts and tighten them to the spec-
ified torque.
6. Install the tailpipe cover and align the bolt
holes.
7. Install the bolts and tighten them to the spec-
ified torque.
WARNING
EWB02341
Do not start the engine when cleaning the
spark arrester, otherwise it could cause injury
to the eyes, burns, carbon monoxide poison-
ing, possibly leading to death, and start a fire.
Always let the exhaust system cool prior to
touching exhaust components.
EBU26812
Adjusting the engine idling speed
The engine idling speed must be checked and, if
necessary, adjusted as follows at the intervals
specified in the periodic maintenance and lubrica-
tion chart.
TIP
A diagnostic tachometer is needed to make this
adjustment.
1. Start the engine and warm it up.
2. Attach the tachometer to the spark plug lead.
1. Tailpipe
2. Spark arrester
Tightening torque:
Retainer bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
2
Tightening torque:
Tailpipe cover bolt:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
U2LS61E0.book Page 27 Friday, April 17, 2015 8:25 AM
