4-4
4
EBU18065
Handlebar switches
EBU18081
Engine stop switch “
/
”
Set this switch to “
” before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this
switch to stop the engine in an emergency situa-
tion. The engine will not start or run when this
switch is set to “
”.
EBU18102
Start switch “
”
Push this switch to crank the engine with the start-
er. See the starting instructions on page 6-1 prior
to starting the engine.
EBU18155
Light switch “
/
/OFF”
Set this switch to “
” to turn on the low beams
and the taillight. Set the switch to “
” to turn on
the high beams and the taillight. Set the switch to
“OFF” to turn off all the lights.
NOTICE
ECB00044
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it. (See page 8-45.)
EBU18283
Throttle lever
Once the engine is running, pushing the throttle le-
ver will increase the engine speed.
1. Light switch “
/
/OFF”
2. Engine stop switch “
/
”
3. Start switch “
”
1
2
3
U2LS61E0.book Page 4 Friday, April 17, 2015 8:25 AM
