8-12
8
2. Start the engine, warm it up for several minu-
tes, and then turn it off.
3. Place an oil pan under the engine to collect
the used oil.
4. Remove the engine oil filler cap, and then re-
move the engine oil drain bolt to drain the oil
from the crankcase.
NOTICE:
When remov-
ing the engine oil drain bolt, the compres-
sion spring, oil strainer and O-ring will fall
out. Take care not to lose these parts.
[ECB00312]
5. Clean the oil strainer with solvent.
6. Discard the old engine oil drain bolt O-ring,
and then apply a thin coat of clean engine oil
to the new O-ring.
7. Install the oil strainer, the compression
spring, the new O-ring and the engine oil
drain bolt. Tighten the engine oil drain bolt to
the specified torque.
NOTICE:
Before in-
stalling the engine oil drain bolt, be sure to
install the O-ring, compression spring and
oil strainer.
[ECB00322]
8. Refill with the specified amount of the recom-
mended engine oil.
1. Engine oil drain bolt
2. O-ring
3. Compression spring
4. Oil strainer
4
3
2
1
Tightening torque:
Engine oil drain bolt:
15 N·m (1.5 kgf·m, 11 lb·ft)
Recommended oil:
See page 10-1.
Oil quantity:
0.80 L (0.85 US qt, 0.70 Imp.qt)
UBD364E0.book Page 12 Monday, January 28, 2019 9:30 AM
Summary of Contents for YFM90 2019
Page 2: ...DIC183 Original instructions Notice originale Manual original PRINTED IN TAIWAN 2019 01 E F S ...
Page 23: ...2 7 2 UBD364E0 book Page 7 Monday January 28 2019 9 30 AM ...
Page 56: ...7 1 7 EBU21142 RIDING YOUR ATV UBD364E0 book Page 1 Monday January 28 2019 9 30 AM ...
Page 123: ...11 2 11 1 Model label 1 UBD364E0 book Page 2 Monday January 28 2019 9 30 AM ...
