8-49
8
EBU27482
Installing a wheel
1. Place the ATV on a level surface.
2. Install the wheel and the nuts.
TIP
When installing the wheel, make sure its arrow
mark
points toward the rotating direction of
the wheel.
3. Lower the ATV to the ground.
4. Tighten the wheel nuts to the specified
torques.
EBU25741
Troubleshooting
Although Yamaha ATVs receive a thorough in-
spection before shipment from the factory, trouble
may occur during operation. Any problem in the
fuel, compression, or ignition systems, for exam-
ple, can cause poor starting and loss of power.
The following troubleshooting charts represent
quick and easy procedures for checking these vi-
tal systems yourself. However, should your ATV
require any repair, take it to a Yamaha dealer,
whose skilled technicians have the necessary
tools, experience, and know-how to service the
ATV properly.
Use only genuine Yamaha replacement parts. Im-
itation parts may look like Yamaha parts, but they
are often inferior, have a shorter service life and
can lead to expensive repair bills.
1. Arrow mark
Tightening torques:
Front wheel nut:
45 Nm (4.5 m·kgf, 33 ft·lbf)
Rear wheel nut:
45 Nm (4.5 m·kgf, 33 ft·lbf)
U1TD61E0.book Page 49 Tuesday, July 8, 2014 11:30 AM
