8-27
8
4. Install the gasket, tailpipe, and retainer and
align the bolt holes.
5. Install the bolts and tighten them to the spec-
ified torque.
6. Install the tailpipe cover and align the bolt
holes.
7. Install the bolts and tighten them to the spec-
ified torque.
WARNING
EWB02341
Do not start the engine when cleaning the
spark arrester, otherwise it could cause injury
to the eyes, burns, carbon monoxide poison-
ing, possibly leading to death, and start a fire.
Always let the exhaust system cool prior to
touching exhaust components.
EBU29703
Adjusting the throttle lever free play
The throttle lever free play should be checked and,
if necessary, adjusted at the intervals specified in
the periodic maintenance and lubrication chart.
The throttle lever free play should measure 2.0–4.0
mm (0.08–0.16 in) as shown. Periodically check
the throttle lever free play and, if necessary, adjust
it as follows.
1. Slide the rubber cover back.
2. Loosen the locknut.
1. Tailpipe
2. Spark arrester
Tightening torque:
Retainer bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
2
Tightening torque:
Tailpipe cover bolt:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
U1TD6AE0.book Page 27 Wednesday, January 8, 2014 8:46 AM
