28
Tying the Rotor Strings
●
Wind the string as shown in the illustration below, and tighten the string
stopper screw.
Wind the string around the screw in the same direction that the screw tightens. After winding, use
the String Stopper Screw B to adjust the lever’s height.
Rotor Stem Screw
String Stopper
Screw B
String Stopper
Screw A
Lever Linkage
Lowers the lever
Raises the lever
The YHR-567/567D is used in this illustration.
■
Switching the 4th Lever Function
●
F/B
b
Double Horn
The Yamaha double horn is designed so that it normally plays in the key of F (open F) when the 4th
lever is not depressed, and in the key of B
b
when the 4th lever is depressed. However, by re-configur-
ing the linkage as shown in the illustration below, this function can be reversed so that the horn plays
in B
b
(open B
b
) when the lever is not depressed, and in the key of F when the lever is depressed.
To use this setup, move the string and the string seat, then place the string over the string seat.
String Stopper
Screw B
Rotor Stem Screw
Lever Linkage
String Stopper
Screw A
Open F
Open B
b
The YHR-567/567D is used in the illustration.
horn̲om̲003-074̲080711.pm
08.9.22, 1:54 PM
Page 28
Adobe PageMaker 6.5J/PPC
