5-13
Periodic maintenance
2.
Check the clearance between the auger end and
the road surface.
3.
Lift the auger housing, using the auger housing
height control lever.
4.
Loosen the nuts of the skid.
5.
Adjust the skid height by moving the skid vertically,
and then tighten the nuts of the skid.
6.
Contact the skid to the road surface, using the
auger housing height control lever.
7.
Check the clearance between the auger end and
the road surface.
1
2
3
4
1. Skid
2. Auger end
3. Road surface
4. Clearance
Clearance between the au-
ger end and the road surface
Factory set
(Standard position)
5 mm
Concrete and asphalt roads
Decrease
Pebble and gravel roads
Increase
1
2
1. Auger housing height control lever
2. Auger housing
2
1
1. Skid
2. Nut
If the clearance between the road surface and the
auger end is too small, auger wear may increase
and the road surface could be damaged.
NOTICE
7XE-28199-U6-E0.book 13 ページ ２０２０年５月１日 金曜日 午後３時４３分
