5-14
Periodic maintenance
TIP
Adjust the left and right skids so they are both the
same height.
8.
Tighten the nuts of skid to the specified torque.
Replacing the auger shear bolts
1.
Stop the engine and remove the engine switch key.
2.
Be sure to use the clean-out tool (lodged snow
remover) to remove snow and other obstacles from
the auger housing.
3.
Remove the locknuts, the shear bolts and the
washers.
4.
Install the new shear bolts with their washers.
5.
Install the new locknuts and then tighten them to
the specified torque.
Tightening torque:
Nut:
16 N·m (1.6 kgf·m)
• Do not look into or put your hands near the
impeller or auger when they are rotating.
• When removing snow lodged in a rotating part
with the clean-out tool (lodged snow remover),
stop the engine, remove the engine switch key,
and wait until all moving parts have stopped.
• Position the Snowblower on a level surface.
• Wear gloves when using the clean-out tool
(lodged snow remover) to avoid injuries.
WARNING
1
1
3
3
2
3
3
1
1
1. Locknut
2. Shear bolt
3. Washer
7XE-28199-U6-E0.book 14 ページ ２０２０年５月１日 金曜日 午後３時４３分
