– 38 –
1. Throttle lever
2. “FAST (START) ”
3. “SLOW
”
5. To stop the Snowblower, lower the
auger to the ground and move the shift
lever to a position other than the “N”
(Neutral) position.
WARNING
Position the Snowblower on a level sur-
face.
MOVING THE SNOWBLOWER
WITH THE ENGINE STOPPED
Follow the step below to move the Snow-
blower with the engine stopped.
NOTICE
• Do not start the engine.
• Position the Snowblower on a level
surface before beginning the follow-
ing procedure.
1. Ring
2. Sprocket pin
3. Hole
4. Sprocket wheel
1. Remove the sprocket pin from the
wheel by pulling on the ring.
2. Insert the sprocket pin into the hole of
the wheel axle.
3. Fold the ring of the sprocket pin down-
ward to lock it. The sprocket wheel is
now freed from the wheel axle.
TIP
Repeat steps 1 to 3 for the sprocket wheel
on the opposite side of the Snowblower.
4. Move the Snowblower to the desired
area.
2
3
1
2
3
1
4
OPERATION
7VY-9-70_E0.fm 38 ページ 2010年4月30日 金曜日 午前9時35分