PLAYBACK
➤
Listening to the sound from a Bluetooth device
En
49
• Perform pairing with the
Bluetooth
device and unit within 10 m (33 ft) of each
other.
• Up to eight
Bluetooth
devices can be pairing with the unit. If a ninth device is
paired, the oldest pairing information is deleted.
• If pairing information for a device is deleted, to use that device again, pairing of the
device is required again.
• If a
Bluetooth
device is already connected to the unit, terminate that
Bluetooth
connection, then perform pairing with the new device.
• Refer to “Bluetooth” (p. 67) in “Troubleshooting” if paring is not possible.
Playing back audio from a
Bluetooth
device
on the unit
1
Press the key on the remote control.
“
Bluetooth
” is selected as the input.
2
Turn on the
Bluetooth
device.
When a
Bluetooth
device is properly connected, the
following is displayed in this unit’s front panel display.
3
Play back a song on the
Bluetooth
device.
• Perform
Bluetooth
connection with the device and unit within 10 m (33 ft) of each
other.
• It may be necessary to select “YSP-2500 Yamaha” in the
Bluetooth
device list
again, in the event that a connection problem occurs. You may have to change the
output setting to output audio to the unit, depending on the
Bluetooth
device you
are using.
• Adjust the volume level of the
Bluetooth
device as required.
• If a
Bluetooth
device is already connected to the unit, terminate that
Bluetooth
connection, then connect with the new device.
• “BLUETOOTH”, or the name of the connected device, is displayed in the front
panel display. “_” is displayed for non-alphanumeric characters in the device
name.
Terminating
Bluetooth
connection
Bluetooth
connection is terminated in the following cases. When the
Bluetooth
connection is terminated, “Disconnect” is displayed in
this unit’s front panel display.
• The
Bluetooth
device is turned off.
• The key is pressed for more than 3 seconds.
• The unit is turned off.
BLUETOOTH
Connect
