SETTINGS
➤
Advanced setup
En
90
Advanced setup list
1)
When “MODE 1” is selected, use a high-speed HDMI cable that supports 18 Gbps.
Menu
Settings/Adjustable range
Description
TURN ON VOLUME
OFF (Not set) (default), 1 to 70
Set the initial volume level when the power of this unit is turned on.
When set to “OFF”, volume level is the same as when this unit is turned off.
MAX VOLUME
1 to 99, MAX (Maximum) (default)
Set the maximum volume level so that this unit will not output sound beyond the limited volume level.
INPUT LOCK
ON (INPUT key operation is disabled)
OFF (INPUT key operation is enabled) (default)
Select whether or not to enable the INPUT key on the unit.
PANEL LOCK
ON (Key operation on the unit is disabled)
OFF (Key operation on the unit is enabled) (default)
Select whether or not to enable key operations on the unit (except the advanced setup operations).
IR INPUT POWER
ON (Enables power-on)
OFF (Disables power-on) (default)
Select whether or not to automatically turn on this unit by pressing an input selector key on the remote
control when the unit is turned off.
AC ON STANDBY
ON (Enters standby mode) (default)
OFF (Restores the state before power was lost)
Set this unit’s power to off when the AC power is recovered after the power to this unit was lost temporally
(disconnect the AC power plug from the wall outlet, power outage, etc.).
MEMORY PROTECT
ON (Protect is performed)
OFF (Protect is not performed) (default)
Protect settings stored in system memory, and Internet radio stations registered with the unit.
YRB FL
YES (The reflection board is used)
NO (The reflection board is not used) (default)
Use the YRB-100 sound reflection board for the front left channel. Refer to page 103 for details of YRB-100.
YRB FR
YES (The reflection board is used)
NO (The reflection board is not used) (default)
Use the YRB-100 sound reflection board for the front right channel. Refer to page 103 for details of
YRB-100.
YRB SL
YES (The reflection board is used)
NO (The reflection board is not used) (default)
Use the YRB-100 sound reflection board for the surround left channel. Refer to page 103 for details of
YRB-100.
YRB SR
YES (The reflection board is used)
NO (The reflection board is not used) (default)
Use the YRB-100 sound reflection board for the surround right channel. Refer to page 103 for details of
YRB-100.
AUTO POWER STANDBY
ON (This unit turns off automatically) (default setting for U.K. and
Europe models)
OFF (This unit does not turn off automatically) (default setting
other than U.K. and Europe models)
When set to “ON”, this unit turns off automatically in any of the following situations:
• Audio is coming from the selected input source, but no operations have been performed for 8 hours or
more.
• HDMI1– 3,
Bluetooth
or NET is selected as the input source, but no audio has been input to the unit or no
operations have been performed with the unit for more than 20 minutes.
NOTICE OF NEW FW
ON (Notify) (default)
OFF (Do not notify)
Notifications will not be displayed on the TV screen when updates for the unit’s firmware are provided via
the network.
4K MODE
MODE 1
1)
Inputs/outputs 4K (60 Hz/50 Hz) signals in 4:4:4, 4:2:2 or 4:2:0 format.
Depending on the connected device or HDMI cables, video may not be displayed correctly. In this case,
select “MODE 2”.
MODE 2 (default)
Inputs/outputs 4K (60 Hz/50 Hz) signals in 4:2:0 format.
