12
En
c
Auto setup for appropriate surround effects (IntelliBeam)
First use the “IntelliBeam” function to adjust each channel so that this unit provides the
optimal viewing and listening environment.
• The AUTO SETUP procedure may not be run successfully if this unit is installed in one of the rooms
described in “Unrecommended listening environments” (p. 7).
The My Surround function can be used to enjoy rich surround sound in these types of rooms as well. See
“Channel Out” (page 73 in the Owner’s Manual) for more information.
• Do not connect the IntelliBeam microphone to an extension cable as doing so may result in an inaccurate
sound optimization.
1
Place the IntelliBeam microphone at your normal listening position.
❑
Assembling the supplied cardboard microphone stand
• Use the supplied cardboard microphone stand or a tripod to place the IntelliBeam
microphone at the same height as your ears would be when you are seated.
• Position the IntelliBeam microphone so that it is parallel with the floor.
Make sure that there are no obstacles between the IntelliBeam microphone and the
walls in your listening room as these objects obstruct the path of sound beams.
However, any objects that are in contact with the walls will be regarded as a protruding
part of the walls.
c
Auto setup for appropriate surround effects (IntelliBeam)
Installing the IntelliBeam microphone
1
2
3
5
4
Remove
Fit in
Run through
Place horizontally
Fit in
IntelliBeam microphone
Upper limit
Within 1 m
Center height of
this unit
Cardboard
microphone stand
Within 1 m
Listening position
1.8 m or more
Lower limit
Center line
IntelliBeam microphone
Cardboard microphone stand
1 2 3 4
