– 52 –
PERIODIC MAINTENANCE
REPLACING THE AUGER
SHEAR BOLTS
WARNING
9
Do not look into or put your hands
near the impeller or auger when they
are rotating.
9
When removing snow lodged in a
rotating part with the clean-out tool
(lodged snow remover), stop the en-
gine, remove the engine switch key,
and wait until all moving parts have
stopped.
9
Position the Snowblower on a level
surface.
9
Wear gloves when using the clean-
out tool (lodged snow remover).
1. Stop the engine and remove the engine
switch key.
2. Be sure to use the clean-out tool (lodged
snow remover) to remove snow and
other obstacles from the auger housing.
3. Remove the locknuts, the shear bolts
and the washers.
1
1
2
3
3
3
3
1. Locknut
2. Shear bolt
3. Washer
4. Install the new shear bolts with their
washers.
5. Install the new locknuts and then tighten
them to the specified torque.
Tightening torque:
Locknut:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
NOTICE
9
Tighten the locknuts to the specified
torque. Shear bolts may be damaged
if they are loosely installed.
9
Use genuine shear bolts only.
7T0-28199-70-E0.indd 52
2019/05/01 9:23:02
