8-18
8
TIP
A “
” mark is stamped on the crankcase
near the engine oil drain bolt for easy identifi-
cation.
10. Install the engine oil drain bolt, engine oil
tank drain bolt and their new gaskets,
and then tighten the bolts to the specified
torques.
11. Add 2.00 L (2.11 US qt, 1.76 Imp.qt) of
the recommended engine oil to the oil
tank, and then install and tighten the en-
gine oil tank filler cap and the cylinder
head cap.
12. Start the engine, warm it up for several
minutes, and then turn it off.
13. Remove the engine oil tank filler cap, and
then add sufficient oil of the recommend-
ed type to raise it to the maximum level
mark on the dipstick.
1. Engine oil drain bolt
2. Gasket
3. “
” mark
1
2
3
Tightening torques:
Engine oil drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Engine oil tank drain bolt:
16 Nm (1.6 m·kgf, 12 ft·lbf)
U2HC70E0.book Page 18 Monday, August 17, 2015 11:59 AM
