9-61
9
3. Install the battery holding plate by install-
ing the bolts.
4. Install the panel.
TIP
Make sure the battery leads are installed as
shown.
Fully charge the battery before installing it.
EBU35244
Jump-starting
Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
WARNING
EWB03430
To avoid battery explosion and/or serious
damage to the electrical system:
Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
Do not touch the positive lead of the
jumper cable to the negative lead.
Do not reverse the polarity of the jumper
cables when connecting to the batteries.
However, if the vehicle must be jump-started,
proceed as follows.
1. Turn the key to “
” (off).
2. Remove panel A. (See page 9-10.)
3. Remove the passenger seat cushion.
1. Positive battery lead (red)
2. Negative battery lead (black)
3. Battery
1
2
3
UB5J12E0.book Page 61 Monday, December 14, 2020 11:51 AM
