9-18
9
2. Turn the panel lock 1/4 turn counter-
clockwise, and then push the tab on the
panel lock down so that it is pointing rear-
ward.
EBU3543A
Engine oil and oil filter
Check the engine oil level before each opera-
tion. In addition, change the oil and the oil fil-
ter cartridge at the intervals specified in the
periodic maintenance chart.
NOTICE
ECB03020
Do not use oils with a diesel specifica-
tion of “CD” or oils of a higher quality
than specified. In addition, do not use
oils labeled “ENERGY CONSERVING II”
or higher.
Make sure that no foreign material en-
ters the oil tank.
To check the engine oil level
1. Park the vehicle on a level surface.
2. Remove panel D. (See page 9-11.)
3. Start the engine and warm it up to a nor-
mal operating temperature (the engine oil
temperature should reach 60 °C [140 °F]),
then let the engine idle for a minimum of
ten seconds before turning the engine off.
TIP
If the engine is cold, take the vehicle for a
short drive or let it idle for approximately ten
minutes before checking the engine oil level.
Recommended engine oil:
YAMALUBE
5W-30, 10W-30, 10W-40, 15W-40, 20W-
40, 20W-50
Oil quantity:
Oil change only:
2.50 L (2.64 US qt, 2.20 Imp.qt)
Oil change and filter replacement:
2.70 L (2.85 US qt, 2.38 Imp.qt)
UBAS7AE0.book Page 18 Wednesday, June 19, 2019 11:51 AM
