5-42
5
4. Tighten the locknut to the specified
torque.
NOTICE:
Always tighten the
locknut against the adjusting nut, and
then tighten it to the specified torque.
[ECB00082]
Crossover setting
The crossover setting adjusts the timing when
the shock absorber transitions from the soft
spring to the hard spring.
TIP
It is recommended to adjust the crossover
setting a similar distance whenever the
spring preload is adjusted.
The crossover setting is measured from the
bottom of the spring retainer to the top of
the crossover locknut.
Spring preload setting:
Minimum (soft):
Distance A =
610.9 mm (24.05 in)
Standard:
Distance A =
598.2 mm (23.55 in)
Maximum (hard):
Distance A =
585.5 mm (23.05 in)
1. Distance A
11
1
Tightening torque:
Locknut:
41 N·m (4.1 kgf·m, 30 lb·ft)
UBDW11E0.book Page 42 Wednesday, June 7, 2023 11:11 AM
