FUEL INJECTION SYSTEM
8-40
TIP
Before troubleshooting, disconnect the starter motor lead from the starter relay.
Fault code No.
44
Item
EEPROM fault code number: an error is detected while read-
ing or writing on EEPROM.
Fail-safe system
Able/Unable to start engine
Able/Unable to drive vehicle
Diagnostic code No.
60
Diagnostic tool display
EEPROM fault code display
• 00: No fault
• 01: CO adjustment value
• 07: Setting tool adjustment values 0–8 for fuel injection amount or
ignition timing
Procedure
—
Item Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service
completion
1
Locate the malfunction
Execute the diagnostic mode
(Code No. 60).
00: Go to item 4.
01: Go to item 2.
07: Go to item 3.
—
2
“01” is indicated in Diagnostic
mode (Code No. 60) EEP-
ROM data error for adjust-
ment of CO concentration
Change the CO concentra-
tion, and rewrite in EEPROM.
After this adjustment, push
the engine stop switch, then
push the start switch.
Memory not recovered
Re-
place the ECU.
Push the start switch.
Fault code number is not dis-
played
Service is finished.
Fault code number is dis-
played
Repeat the proce-
dure in item 1. If the same
number is indicated, perform
the procedure in item 4.
3
“07” is indicated in Diagnostic
mode (Code No. 60) EEP-
ROM data error for setting
tool adjustment values for
fuel injection amount or igni-
tion timing.
Erase the setting map in the
diagnostic mode (diagnostic
code No. 65).
Push the start switch.
Fault code number is not dis-
played
Service is finished.
Fault code number is dis-
played
Repeat the proce-
dure in item 1. If the same
number is indicated, perform
the procedure in item 4.
4
Malfunction in ECU.
Replace the ECU.
Summary of Contents for YZ 2015 Series
