FUEL INJECTION SYSTEM
8-35
2
Installed condition of lean an-
gle sensor.
Check the installed direction
and condition of the sensor.
Push the start switch.
Fault code number is not dis-
played
Service is finished.
Fault code number is dis-
played
Go to item 3.
3
Defective lean angle sensor. Execute the diagnostic mode.
(Code No. 08)
Replace if defective.
Push the start switch.
Fault code number is not dis-
played
Service is finished.
Fault code number is dis-
played
Go to item 4.
4
Malfunction in ECU.
Replace the ECU.
Fault code No.
33
Item
Ignition coil: open or short circuit detected in the primary lead
of the ignition coil.
Fail-safe system
Unable to start engine
Unable to drive vehicle
Diagnostic code No.
30
Actuation
Actuates the ignition coil five times at one-second intervals.
The “WARNING” on the Yamaha diagnostic tool screen come on
each time the ignition coil is actuated.
Procedure
Check that a spark is generated five times.
• Connect an ignition checker.
Item Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service
completion
1
Connection of ignition coil
coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
Improperly connected
Connect the coupler securely
or repair/replace the wire har-
ness.
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played
Service is finished.
Fault code number is dis-
played
Go to item 2.
2
Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
Improperly connected
Connect the coupler securely
or repair/replace the wire har-
ness.
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played
Service is finished.
Fault code number is dis-
played
Go to item 3.
Fault code No.
30
Item
Latch up detected.
Summary of Contents for YZ 2016 Series
