7-20
SETTING
TUN
NOTE:
9
If the machine is new and after it is broken in,
the same set length of the spring may change
because of the initial fatigue, etc. of the spring.
Therefore, be sure to make re-evaluation.
9
If the standard figure cannot be achieved by
adjusting the spring adjuster and changing the
spring set length, replace the spring with an
optional one and make re-adjustment.
EC72G020
Setting of spring after replacement
After replacement, be sure to adjust the spring to
the set length [sunken length 90~100 mm
(3.5~3.9 in)] and set it.
1. Use of soft spring
9
Set the soft spring for less rebound damp-
ing to compensate for its less spring load.
Run with the rebound damping adjuster
one or two clicks on the softer side and
readjust it to suit your preference.
2. Use of stiff spring
9
Set the soft spring for more rebound damp-
ing to compensate for its greater spring
load. Run with the rebound damping
adjuster one or two clicks on the stiffer side
and readjust it to suit your preference.
Adjusting the rebound damping will be fol-
lowed more or less by a change in the com-
pression damping. For correction, turn the
low compression damping adjuster on the
softer side.
5NX-9-30-7 6/5/01 4:48 PM Page 44
Summary of Contents for YZ250(P)/LC
