Instrument an
d
control functions
4-8
4
EAU46283
Seat
To remove the seat
Remove the bolts, and then slide the
seat to the rear and pull upward.
To install the seat
1. Fit the slot in the seat onto the pro-
jection on the fuel tank, and insert
the projection on the seat into the
seat holder as shown.
2. Place the seat in the original posi-
tion, and then tighten the bolts.
TIP
Make sure that the seat is properly se-
cured before riding.
EAU41474
A
d
justin
g
the front fork
WARNING
EWA10181
Always a
d
just
b
oth fork le
g
s equally,
otherwise poor han
d
lin
g
an
d
loss of
sta
b
ility may result.
This front fork is equipped with re-
bound damping force adjusting screws
and compression damping force ad-
justing screws.
NOTICE
ECA10102
To avoi
d
d
ama
g
in
g
the mechanism,
d
o not attempt to turn
b
eyon
d
the
maximum or minimum settin
g
s.
Re
b
oun
d
d
ampin
g
force
To increase the rebound damping for-
ce and thereby harden the rebound
damping, turn the adjusting screw on
each fork leg in direction (a). To de-
crease the rebound damping force and
thereby soften the rebound damping,
turn the adjusting screw on each fork
leg in direction (b).
1. Bolt
1. Slot
2. Projection
3. Seat holder
1
1
2
3
2
1. Rebound damping force adjusting screw
U1SN16E0.book Page 8 Thursday, June 1, 2017 3:13 PM